Topics created by swickliff

@swickliff I am using Ubuntu 20.04 on both the VM and Linux PC

Hi @swickliff
If this is still troubling you, are you willing to do an RMA so we can inspect and make sure things are solidly setup again for you?
You can get started by reaching out here: rma@modalai.com

@swickliff , I do see SOF received at t=203.337935 and t=203.371313, however there are errors reported right after. It looks like there is actually a issue in data transmission over the high-speed camera interface.

Since the same camera unit appears to be working when plugged into a different camera port (per your report), it seems there is some damaged that occurred on the original camera connector or components around the connector. Please inspect the connector and surrounding components again.

Alex

@Alex-Kushleyev Thanks for all the info! I'll keep those things in mind when soldering to the pads.

@tom That worked! thanks for the help

@swickliff, if only 1 out of 4 LEDs is blinking, that is very strange. When power is applied to the ESC, the bootloader on each ESC channel should always start and blink the blue led fast for 1 second. after that, firmware execution starts. If LED is not blinking at first, then there is most likely some HW issue that prevents the ESCs from booting. I am surprised that one out of four LEDs is actually blinking.

Our ESCs are all tested during production (including spinning), but if you think that you received the ESC in a non-working state (it was not damaged after receiving it), then you should submit an RMA form for a replacement. https://www.modalai.com/pages/rma

@swickliff please submit a request at https://modalai.com/rma .