Issues with Microhard connection and VOXL 2
-
Check out this animated setup here
-
This post is deleted! -
@aimseis Can you post a picture of your setup?
-
This post is deleted! -
This post is deleted! -
@aimseis which operating system is your PC running? If it's Linux, can you type
lsusb? -
This post is deleted! -
@aimseis You likely have to install a LAN7500 driver on your windows machine
-
This post is deleted! -
@aimseis We can only really help with support on linux, I specifically recommend with Ubuntu 22.04.
-
This post is deleted! -
@aimseis
-
The voxl-modem service doesn't need to keep running for the entire time. All it does is a run a few initialization steps and then exits, so that's not an issue.
-
I'll get someone from the hardware team to comment
-
-
@tom said in Issues with Microhard connection and VOXL 2:
@aimseis
- I'll get someone from the hardware team to comment
Per Microhard the ABS max of the 5V rail is +10% consistent with USB specs, so 5.5V.
Anything above that will risk damage to your device.
There are other components on our M0048 design that will be damaged at 6V.What voltage did you apply to this board @aimseis ?
-
This post is deleted! -
This post is deleted! -
Hi @aimseis
When you use a plug-in board with Voxl or Voxl2, they and the plug-in board manage the input 5V and other voltages so all you need is to provide the correct power module to your Voxl or Voxl2, and the rest is handled.I'm not able to provide answers on shipping time as I am in Hardware Engineering, not shipping/production. Sorry.
-
This post is deleted! -
@aimseis Are you able to ping the voxl from your pc over the Microhard network?
-
This post is deleted! -
This post is deleted!
