VOXL 2 Ethernet and USB Hub Add-on with Doodle lab radio
-
Hi,
Can I connect a doodle lab radio to the J12 connector on the Ethernet and USB Hub board?
I have connected it and ran voxl-configure-modem
When I check ifconfig eth0 the IP details looks correct but I cannot ping any other IP address on the Doodle network.
Regards
Aidan -
@AidanGallagher Are you able to ping the doodle modem itself? Also double check you aren't trying to use an IP that is already being used on the doodle network
-
@tom Cannot ping the modem and I am certain its a free IP address.
I tried a USB Expansion Board with Fastboot v2 I had on another setup and it works so the issues does seem to be on related to this board.
Is there a jumper I need to set to enable the J12 header?Regards
Aidan -
@AidanGallagher Can you post a picture of the setup you're using?
-
@tom ill do that tomorrow when I'm back in the office
-
-
That's my working solution
-
-
This solution doesn't work
-
@AidanGallagher With an M0130 USB breakout board
M0130: https://www.modalai.com/products/m0130-3?variant=48186331693360
You can use this cable:
MCBL-00085: https://www.modalai.com/products/mcbl-00085?_pos=2&_sid=0c5d87c5e&_ss=rand get rid of the need for the doodle breakout board
