Topics created by QSL

@tom said in Missing Config File:

voxl-configure-vision-hub factory_enable

thanks. I tried the Sku Wizard then MPA but I seem to still have a blank file when I open it in nano. I will try the factory default next.

@Moderator This is appreciated, I had however already seen these docs. My issue is that though you have a 15cm extension that does not account for the orientation of the Voxl2 in relation to the sensor and location to mount them. due to this the 15cm connector is not long enough. Is there any advice on how we can extend these sensors beyond these lengths? Is there some shielding or other potential signal boosting we can do? Our goal is to eventually be able to position the sensors further away from the voxl2 as we want to use the hardware on much larger platforms where the rear sensors will need to be further than our current test development.

TIA for any insight.

What have you guys done to stream the video to QGC? do you use a wifi dongle?

@QSL Hi, thank you for reaching out. There are many ways to achieve what you are trying. Starling 2 is the best starting point. You can then learn about what will work and what will not work and build out your system design from there.