ModalAI Forum

@Moderator Thank you for reply. This connecter is not working. [image: 1706060134869-9bb90eef-d3df-44a6-9311-3521bcc67dca-image.png] I connect usb3-camera device into this connecter, but not recognized. I checked to using bellow commands lsusb: did not add new device. dmesg: did not output new kernel messages(info. warn error etc.). When using Cable USB3 10-pin JST, usb3-camera device is recognized and working. So I think hub IC and peripheral circuit are working.

HI @iksk That stiffener on the older units is not a shield. It's just floating metal (stainless steel). We have since moved away from all metal stiffeners due to electrical shorting risks in tight drone assemblies, and all new flexes have the laminate backers now. The laminate is slightly thicker at 0.8mm instead of 0.2mm. If you are seeing performance issues between the two, it is purely coincidence and likely more result of manufacturing variance or handling resulting in degradation. We have built and tested thousands of the new ones and there are no stability differences between them. Hope that helps.

@Alex-Kushleyev Thank you for some comments. I was able to be streaming, recording and video playback well! I will be more considering about image preprocessing.