QGC Not Connecting to the Sentinel
Hello, I am following this QuickStart Guide, but my QGC is unable to connect to the Sentinel drone.
- The drone is successfully connected to the WiFi
ifconfig# On the Drone
ifconfig# On the Host Laptop
- I can Ping from the drone to my Host laptop, and vice-versa
- I mentioned the Host IP Address inside the voxl-vision-px4.conf
Still, when running the QGC on Host, it shows disconnected
@Raza-Rizvi can you make sure that there's no firewall setup blocking the connection.
Could you also provide the output of
systemctl status -l voxl-vision-px4
Yes, the firewall is disabled.
Here's the output to the mentioned command:
The mavlink server is also running
@Raza-Rizvi are you connected over softap or station?
Can you ssh into the drone?
I am connected over station. And Yes, I can SSH to the drone.
@Raza-Rizvi Please post the output of “voxl-inspect-services” and “voxl-version”
@Raza-Rizvi That error message "voxl-mavlink-server does not appear to be running" isn't normal. You may want to run through
voxl-configure-mpaagain, set your host IP in
voxl-vision-px4.conf, then reboot your drone.