@McMason Can you please guide me on how to solve this issue?
I am having a similar problem with the Sentinel drone, when I run the voxl-mavlink-server -r command, there is no main loop being triggered.
Hence, I am also unable to see the drone connected to the QGround controller.
I am connected over station. And Yes, I can SSH to the drone.
Yes, the firewall is disabled.
Here's the output to the mentioned command:
The mavlink server is also running
The main issue is this.
In order to debug this, I am trying to see if my mavlink server is working fine.
The send works fine (apparently)
voxl-mavlink-server --debug_send
But, the recv is not working
voxl-mavlink-server --debug_recv
Can it be related to the ports mentioned inside the mavlink configuration?
My mavlink conf is:
And the vision-px4 conf. is:
Please help.
Hello, I am following this QuickStart Guide, but my QGC is unable to connect to the Sentinel drone.
ifconfig # On the Drone
ifconfig # On the Host Laptop
Still, when running the QGC on Host, it shows disconnected
Are there any other receivers onboard the Sentinel drone which can be used with Transmitters other than the Spektrum ones?
I've recently ordered the VOXL 2 AI & 5G Development Drone - Sentinel and I am unsure about the R/C control of this drone.
The webpage suggests buying an R/C Transmitter and mentions the Spektrum RC transmitter (e.g. DX6e, SPM8000 or SPMR8000) as a compatible one.
My question is, does the drone comes already with a Spektrum Receiver, which is why we need to buy a Spektrum Transmitter?
If not, are we open to buying any receivers or transmitters?
