PX4 DISCONNECTED FROM UART
-
Hello, I can't connect my seeker to QGC. I have already reconfigured voxl-vision-px4 and voxl-mavlink-server to the factory setting and both of them are enabled and running.
But when I look into it by using status -l voxl-vision-px4, it says:
Jan 01 00:00:09 apq8096 voxl-vision-px4[2589]: WARNING: connected to voxl-mavlink-server but no messages from PX4
And when I check voxl-mavlink-server, it says
Jan 01 00:00:10 apq8096 voxl-mavlink-server[2710]: PX4 DISCONNECTED FROM UART
Here is my mavlink.conf on seeker
I already try my best to fix this and gets no luck...... So hope you guys can help me with it.
Sorry for interrupt your Christmas vacation.
-
Could the cabling between the VOXL and Flight Core have become disconnected? The connections should look like the image below
-
Could the cabling between the VOXL and Flight Core have become disconnected? The connections should look like the image below
@Chad-Sweet Thanks for your quick response.
I check the cable between them and it looks good to me. I also re-plugged some of them and check mavlink status, still shows disconnected.
-
Quick update, mavlink suddenly connected yesterday, but after few minutes it disconnected again. Since I didn't change any of setting, so I think it's bad contact causing the disconnection. What do you guys think of this?
-
yes, it sounds like a cable is not connected or was damaged somehow
-
S Syed Omair referenced this topic on
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login