Propellers spin and then stop

[Kiazoa Joao]

Hello!

I have a development drone (M500) that was purchased from Modal Ai. I was able to get it to connect fine. However, when I try to spin the motors using QGC, they spin only at low speed. Whenever I try to increase the speed, they fail and I lose connection. Can somebody help me figure out what the issue might be?

Regards,
Kiazoa

[pthomason]

@Kiazoa-Joao Are you using the wall power adapter or full batteries? The power adapter doesn't have enough current to support the motors at full speed.

[Kiazoa Joao]

@pthomason Hi! I am using batteries. No power adapter

[Kiazoa Joao]

I just found out that my baud rate was off. I changed it to 2,000,000 and they're working fine now.

[Alex Kushleyev]

@Kiazoa-Joao . Great!

We have recently added a check to voxl-esc tools to prevent setting incorrect baud rates. However, the typo is still possible in PX4. I will add a check on the PX4 param in PX4 voxl esc driver.

Alex

[Kiazoa Joao]

@Alex-Kushleyev sounds good