Screw size for IMX377/M0026
-
I made a custom piece in solidworks for the M0026 HiRes camera and 3D printed the part and it requires longer screws. I have looked at the data sheets and cant seem to find the exact screw they use. The screws fits in nicely to a 1.3mm hole in PLA, wondering if you guys knew the exact screw needed?
-
Hi Ryan,
Apologies for the long response time. I'll do my best to help you.
Our IMX377 camera module housing has those two side mounting holes on the drawing that indicates a diameter of 1.80mm. So as long as you are smaller than that with sufficient retention you should be good to go. The outer "ear" of that hole shows it is a 4.2mm diameter, so you do not want your screw head larger than that.
Hope that helps.
Vinny -
@Vinny no worries, I ended up just going to industrial hardware in SD and trying out a bunch of machine screws until I got one that fit nicely, cant recall the exact size. Here are the dimensions for mounting the M0026 in a part I made. Figured I would post it if it helps someone else out since I personally couldn't find a STEP file for this part. Dimensions are in mm, the camera is ~24.1mm from base to the tip of the lens from my caliper measurements.
