@Nathan-Raras , Hi , we can't able to connect to J6 using MDK-M0135-1-00, with same interpose when connected to J7 it was working fine with hardware ID ( 0 & 1 ) for tracking and hires.
According to the website which you have given was not working. I need the exact hardware ID's while J6 is connected with { tracking - JL & hires - JU }
@Alex-Kushleyev No, we are getting more than that, 1 meter nearly up to 2 meters. We are getting more problems in Position mode.
We also want to connect BMP280 externally to voxl2 mini, is there any process to get that done,
Hi.,
we are using Voxl2-Mini , with out any external flight controller.(Using internal Px4)
We are using a Barometer for height but are having issues while flying.
So, we went to check the px4-listener, here are the results.,
Altitude is continuously going up because the pressure is going down, and the temperature is going up.
we have two voxl2-mini that we are facing the same issue, temp reaching up to 55°C
Due to this flight was Going up and down while flying.
This condition did not take long after power was on.
@Moderator can we get Microhard board schematics , as it was open source , can you help me with that.
Hi, we are using VOXL 2 Mini for our drone. we thought to use Flight Core v2 - PX4 for our project.
we need the schematic of Flight Core v2 - PX4. Where can I find the schematic?
As the dimensions are very problematic for our design.
@Trinadh The issue is clear by using the below commands.
camera-server-config-helper hires:imx214:0 tracking0:ov7251:1
voxl-camera-server -d 3
@Eric-Katzfey , Hi we are using VOXL2 Mini SDK 1.0.0 - i am not attached GPS, RC, ESC. any other peripherals, the output is the same, and PX4 is running at 140% as well.
I have tried using ESC also but the output is the same.
The module is heating up crazy!!!
My Voxl 2 Mini is taking More than 100% cpu , and temperatures are going so up while running the PX4.
Voxl 2 mini is taking nearly - 550mA current at 2S battery.
If we are running other services except PX4 , the temperature was normal
@tom Hi Tom, thank for the input, we have placed the board and camera as per the VOXL document. and the command you specified is also been checked the result was the same.
For reference I am Placing the Camera connection given in VOXL Document
We have placed the camera modules as per picture.
