@Moderator thank you I appreciate it.

I was curious Is the FlightCore V2 Accelerometer thermally Calibrated in the factory?

Hi, I just had a question on using an aftermarket power module being that the one that came with my flight core v2 stopped working.

The After Market pin layout:
-5v
-5v
-Vcurrent
-Vbatt
-GND
-GND

The Flight Core V2 calls for:
-5V
-GND
-I2C3_SCL
-I2C3_SDA

Where can I put the Vcurrent and Vbatt wires to have the flight controller still read the power consumption and voltage?

@Alex-Kushleyev I was able to figure out the issue. The firmware had the baud rate parameter to the wrong speed. After correcting it and setting it to 56,000 it works. Thanks for the Help!

@Alex-Kushleyev
thanks, I'll see what I can do. Basically, the only issue is with the telemetry radio. The Rc receiver works completely fine. They are two separate things and I'm only worried about the telemetry radio. it communicates via Mav-link to the ground station (my laptop running QGC).

@lccarter
Just to clarify I haven't tested with non-telemetry radios.

@Alex-Kushleyev

I've tested both telemetry ports. I only need it for use with telemetry radios because I'm using sbus hardware configuration for my sbus receiver. I've clarified that it's neither the radios or the wires because each of the telem radio sets work with a different flight controller i have. Is there a parameter that I am missing that should be turned on? ESC Telemetry is turned off, so I can utilize Telem 1 for other purposes, such as a telemetry radio, however no matter what port or configuration I have it in, Flight Core 2 does not recognize it. What steps do you propose I take?

@lccarter note. in the title i mean that there were not working. Not instead of Now.

I was wondering is anybody else has had any issues getting telemetry radios to connect to their flight core v2. I saw that on the website and other documentation that telem1 on the Flight controller is reserved for ESC Telemetry, but I should just be able to use telem2 and it should work with my radios. I've tried to use my MRo 900MHz Telemetry Radios and my HolyBro 900MHz Telemetry Radios and no luck. The flight controller is running the latest version of PX4 1.14.0. Any help would be greatly appreciated.