@kitkatSG
Good morning, We can prepare a px4 parameter file for you that will reset the tune. First could you send us a px4 parameter file from your drone? You can send it directly to my email (jeremy.schmidt@modalai.com)

I'll take a look to make sure I send you everything you'll need.

Thanks

@griffin
To extend the wires, you only need to solder splice the correct length of extra wire.

I'm looking into our custom version being available to you. Probably won't have an answer until the morning

@alfa-budiman Good morning, please try reversing all six pwm connections coming from the escs to the breakout board.
Your photo shows them plugged in with incorrect pinout.
This will definitely cause all of the problems you're describing. Thanks and good luck.

@alfa-budiman And I would also suggest going back into QGC and configuring the PWM related params back to their defaults. Once the polarity of the PWM's are correct, you should be able to calibrate successfully.

@griffin
To extend the wires, you only need to solder splice the correct length of extra wire.

I'm looking into our custom version being available to you. Probably won't have an answer until the morning

@Shivam-Sehgal
The glue is an easy to remove RTV silicone adhesive. If you follow the instructions posted by Alex, you should be successful. I've done this myself a couple of times.

After removing you will need to clean away as much of the remaining glue on the voxl2 as possible before installing the new adapter board. You don't necessarily need to apply glue when installing the new board, but we find it helps with keeping the adapter from accidentally teetering at the hirose connector.

Please let me know if you need further help with this matter

@griffin
For Starling MAX, the correct motor is the 2203.5 1500kv.

Did you order them from us? We customize the length of the wires for the Starling MAX specifically, so an "off the shelf" version of that Tmotor will have shorter wires.

@Judoor-0

We apologize for the delayed response. I'd like to get your problem resolved quickly. To help facilitate this, could you please send me your original order number? This will help determine the correct motor to send as a replacement.

I'll await your responses and get things moving for you as quickly as possible

@rohitpillai Good morning,
@Vinny filled me in on your issue and I wanted to check in with you on the status. You mentioned coming by the office and so I also wanted to discuss that option with you. Ease let me know if you're still interested in doing that.

Thanks!

@kitkatSG
Good morning, We can prepare a px4 parameter file for you that will reset the tune. First could you send us a px4 parameter file from your drone? You can send it directly to my email (jeremy.schmidt@modalai.com)

I'll take a look to make sure I send you everything you'll need.

Thanks

@rohitpillai

Good morning,

As long as you complete our online form then we have no problem with you dropping it off to us since you're local.

@alfa-budiman And I would also suggest going back into QGC and configuring the PWM related params back to their defaults. Once the polarity of the PWM's are correct, you should be able to calibrate successfully.

@alfa-budiman Good morning, please try reversing all six pwm connections coming from the escs to the breakout board.
Your photo shows them plugged in with incorrect pinout.
This will definitely cause all of the problems you're describing. Thanks and good luck.

@Slade-Villena

Is it possible? Yes, but we highly discourage modifying our Sentinel platform in this way as we have not built it for these purposes. May I ask how much additional payload mass you're wanting to add?