I was having an issue where my ESC was not connecting. It was being detected by voxl-esc scan, but i could not move the motors in QGC. REsolved this by running voxl-esc upload_params After I updated the firmware on the ESCs, it appears I needed to upload new parameters. That or it never came with those on. After that I set baud to 2000000, and got the motors spinning in QGC Thanks

ModalAI Forum

Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

VOXL ESC not connecting

Unsolved ESCs, Sensors and Accessories

1 Posts 1 Posters 386 Views

W Offline
W Offline
wilkinsaf
ModalAI Team
wrote on last edited by

#1

I was having an issue where my ESC was not connecting. It was being detected by voxl-esc scan, but i could not move the motors in QGC.

REsolved this by running voxl-esc upload_params

After I updated the firmware on the ESCs, it appears I needed to upload new parameters. That or it never came with those on.
After that I set baud to 2000000, and got the motors spinning in QGC

Thanks
1 Reply Last reply

0

Reading along? Create a free ModalAI Forum account to join in.

With an account you can reply, ask your own question, get an email when a ModalAI engineer answers, and mark the reply that solved it. Your place in each thread is saved between visits.

Questions about VOXL, Flight Core, ESCs and ModalAI drones are answered here by the engineers who build them.