ModalAI Forum

@Eric-Katzfey As for now, it is blinking with a red color. I was able to do a compass calibration, but it does not show the location in the map. I'll try to investigate on the matter. Thank you for your responses.

Hey @Eric-Katzfey, I'm using the GPS included with the VOXL2 Flight Deck (https://www.modalai.com/products/voxl-2-gps-mag-rc-assembly?variant=40673762836531).
Do you have any tips on how to update/fix the driver? Just a side note, it was working perfectly fine before I updated to 1.0.0 (previous suite was 0.9.4).
Thanks in advance!

Hello there!

I tried to configure my VOXL2 (1.0.0) with a custom airframe using QGC. However, I encountered an error message when attempting to calibrate the compass:

"Start the individual calibration steps by clicking one of the buttons to the left.
[cal] calibration started: 2 mag
No mags found
[cal] calibration failed: mag"

Any information or assistance would be greatly appreciated!

Cheers.

@tom Thank you for your response! I'll look forward to the new documentation when it becomes available, thanks for the hard work. Cheers!

Heya!
So, I used to rock VOXL2 with the old 0.9.4 Suite. But then I upgraded to the fancy new 1.0.0 Suite. Now I'm trying to figure out how to connect to QGC. Any ideas?
Cheers.