@Alex-Kushleyev
We are designing our custom adapter board which will have mating connector DF56C-26S-0.3V(51) on board to connect MSU-M0186-1-09 camera module.
And we are planning to test synchronicity with other camera. So just wanted to confirm master or slave mode is configured from firmware or is there any dependency on hardware is well for this configuration.
let me know if more details are needed.
Regards,
Richa
We are designing one carrier board and wanted to use Camera module MSU-M0186-1-09
Here, I am attaching schematic image for your reference.
Let me know if more details are needed.
Awaiting for your valuable feedback on the same.
Regards,
Richa
We are designing one carrier board and wanted to use Camera module MSU-M0186-1-09.
We have noticed that the pinout lists Sensor Sync Signal (21st Pin). Could you please confirm if this is FSYNC pin ?
More on this, we wanted to validate camera synchronicity of 2 cameras. Could you please tell us this Module is in Master mode or Slave Mode ? These modes are Software configurable ?
What is the procedure to provide design for review?
@Alex-Kushleyev
Thank you!
What is the procedure to provide design for review?
@Alex-Kushleyev
We have ordered MSU-M0186-1-09 camera module and in image it shows co-axial cable attached to it.
Refer below image for your reference.
So in this case our custom carrier board should have the mating part on which this co-axial cable should attach.
we are expecting that this kind of connector on our carrier board.
Please suggest the highlighted connector part number.
Dear Alex,
I have gone through the link you have provided. Those link is not providing the specific information I required.
We need to connect MSU-M0186-1-09 camera module on our custom carrier board. we do not want to use intermediate adapter boards.
SO we need part number for 26 pin mating connector which can attach with the MSU-M0186-1-09 camera cable?
Let me know if more details are needed.
Regards,
Richa
We are designing one carrier board and wanted to use Camera module MSU-M0186-1-09.
Could you please help me which mating connector we should use on our board to insert 26-pin the co-axial cable with our custom carrier board?
Do let me know if more details are required.
