Hi ModalTB,
I was able to resolve the issue looking deeper into QGroundControl. I had set the system to HITL after following your awesome tutorial:
https://www.youtube.com/watch?v=-uoIxAkiYtk
To fix this, I switched the system back to "Generic Quadcopter" in order to receive battery data.
Thank you for your through response. It helped me to resolve this.
Best Regards,
Justin
Hello,
I'm using MAVSDK with the docker container.
What's the best way to change how fast the drone moves between waypoints. I would like it to move a bit slower.
Best regards,
Justin
Hi ModalTB,
I was able to resolve the issue looking deeper into QGroundControl. I had set the system to HITL after following your awesome tutorial:
https://www.youtube.com/watch?v=-uoIxAkiYtk
To fix this, I switched the system back to "Generic Quadcopter" in order to receive battery data.
Thank you for your through response. It helped me to resolve this.
Best Regards,
Justin
Hello,
I recently purchased a Power Module v3 for a VOXL CAM. When I run "voxl-inspect-battery" I get N/A. This is also received on the web GUI and QGroundControl. I need to have this function working to fly the drone.
To debug I've done the following steps:
Used the command "voxl-i2c scan 8 400000" to see if the VOXL CAM can read any I2C devices on the power port. None showed up. I tested the command on the port with the barometric pressure sensor and the scanner is working properly as it found the device.
I then used a hardware I2C scanner I have and plugged it into the Power Module v3, and it was able to discover the devices at 0x44 and 0x45. The power module appears to be functioning correctly.
I wired a oscilloscope to the output of the VOXL CAM to scan the I2C port and verify the wiring and that the VOXL CAM is sending read commands. I was able to see the commands being sent and that the system is wired correctly.
What can I do to properly setup this module? Is there anything I might be missing?
Thank you,
Justin
I noticed the VOXL ESC v2 is out of stock. 
Is there any way to use the VOXL with a BLHeli_S compadible ESC?
https://github.com/betaflight/BLHeli_S
Also, what was the teams reasoning behind building a ModaAI ESC?
Thank you!
P.S Is there a timeline for restocking them?
Is the Flight Controller on the VOXL compadible with BLHeli Suite (32 Bit) ESCs?