ModalAI Forum

@Vinny no the same still happens when the jeston computer is powered up.

@Vinny any update?

as you can see it has power as shown by the 5v LED but no other leds now light up?

@Vinny I have already tried swapping the boards over between the setups and have removed and reinstalled the modules with care to inspect for damage but have found none.

Both are just being bench tested with a 5v supply.

Without the module installed, would only the 5v led light up anyway? It seems like a the board needs a factory reset as nothing changed with the setup apart from a power cycle.

I have two Microhard pDDL Carrier USB Dongle (MDK-M0048-2-01), both set up the same way but one has stopped working during initial setup.

It was lighting up with all the LEDs on the board but after powering on and off it now only shows the 5v LED.