Hi all
I would like to know what is the current output specification for the power module V3.
Is it a standard 5V 3A output ?

Thanks & Regards,
Mohammed Naveed

Hi all,
I have a silly question
I have been performing VIO flights indoor without any issue. So the drone I am working with is using a pixhawk 4 gps and i am flying indoor. The GPS is disabled but the compass is still enabled. So here is the silly question, I have been always facing north while powering up my drone. Is this method correct to do for performing VIO? My thought process is that the onboard compass is able to determine the true heading, but the VIO tracking camera considers the heading where it was powered on as north.(like if i face east and power on the drone, that heading would show as north on QGC) Wouldnt this create a compass variance error while navigation?

Moving to more advance thing!
How to perform an outdoor (open field) to indoor (basement) transition while in position mode? What should be the steps i need to follow and things i should keep in mind!

Thanks & Regards,
Mohammed Naveed

Hi @Chad-Sweet
Thank you so much!
Will have try it out first on the flight deck.

Thanks & Regards,
Mohammed Naveed

Hi all
I wanted to miniaturise my voxl flight deck, and want to know what aspects should i consider while i make a new flight deck style mounting for the hardware?
As per my understanding the stereo cameras need to be set at a specific distance apart.
However i wanted to know if any parameters need to be changed so the flight core knows where the stereo camera and the tracking camera are?

Thanks & Regards,
Mohammed Naveed

Hi @alarm_hq
You could swap out manual for stabilise mode.
Go to the Vehicle setup>flight modes and select it.

You are right in position mode you should be able to get x/y and z translation.
If you have any obstacles around you, then its probably the collision prevention preventing you from making X/Y translations .

I hope this helps you out!

Regards,
Mohammed Naveed

Hi all
I wanted to know whats the maximum capacity and class micro sd card i can use with the VOXL flight deck.( voxl and flight core)

Thanks & Regards,
Mohammed Naveed

Hi @hmlow
I am facing the same issue as well!

https://forum.modalai.com/topic/696/overlay-of-obstacle-during-collision-prevention

Thanks & Regards,
Mohammed Naveed

Hi @Chad-Sweet
Wanted to know if I want a drone with just the flight core on it and no companion computer. Can i flash arducopter and use this flight core as a simple controller that can perform similar to a pixhawk?

Thanks & Regards,
Mohammed Naveed

Hi @modaltb
Sorry if i didnt mention this earlier. Its a VOXL flight deck which is having this issue. My other VOXL flight deck is working fine and we tried to interchange the board and see where the issue was and found out to be the J12 port. In the other flight deck J12 is working correctly.
I'll try the loop back test.

Thanks & Regards,
Mohammed Naveed

Hi @modaltb
No I can ADB into the voxl, so its not bricked!
This board is brand new and we were just configuring the flight core and we had just updated the custom firmware from v0.0.5 to v0.2.3.
We just wanted to do VOA.
However we found the issue, it seems to be a hardware issue!
The J12 port to which the TELEM cable is connected to is not working correctly. I physically inspected if there are any damages but couldnt find anything wrong.
This voxl was not able to communicate with another flight core as well. But once we shifted to J10 port it started to work correctly.
So is it still hardware issue?

Thanks & Regards,
Mohammed Naveed