Taranis Q X7



  • While trying to get the telemetry information on our Taranis Q X7 I set the TEL_FRSKY_CONFIG to TELEM2. Due to this, I cannot form a connection between the QGgroundControl and the drone.



  • Our documentation explains how to use FrSky telemetry with Flight Core https://docs.modalai.com/flight-core-radios/#frsky



  • Thanks for this. Unfortunately, I managed to set TEL_FRSKY_CONFIG to TELEM2 in QGroundControl and cannot form a connection between the drone and QGC anymore. Is this due to setting that parameter? How this can be fixed?



  • I managed to solve this by connecting QGC through USB.



  • Our Seeker was ordered with the FrSky receiver and our transmitter is FrSky Taranis QX7 ACCST. The only telemetry we see at the moment is the receiver voltage. The telemetry works as expected over wifi between the drone and QGC.

    On the receiver GND, +5V and SBUS_OUT/CPPM are connected. We can confirm that the mode is SBUS (the blued led is solid on the receiver).

    How can we get the telemetry to our transmitter? Do we have to connect some extra cables, update the firmware or something else?


  • Dev Team

    Hi @tomipi ,

    To confirm, this is what you have correct?

    Are you able to get the RC "input" into the system with this setup, and what you aren't getting is telemetry back? This setup below interfaces with an RC Input driver, so I don't think it will be passing telemetry back out... Will check with the guys on what they use here.

    1dcd4b35-189e-4002-ae07-b8b223f5ec01-image.png



  • Hi,

    Yes I believe that is correct, everything is factory installed.

    Are you able to get the RC "input" into the system with this setup, and what you aren't getting is telemetry back?

    Yes, everything else except the telemetry from the drone to the transmitter is working.


Log in to reply