Starling V2: Manual control not working
-
Hello,
I RMA'd one of my Starling V2's a couple of months ago for a replacement voxl2. Yesterday, I tried to fly it for the first time since getting it back but I am having difficulty getting the RC to talk to the voxl. I'm using the Ghost Atto + Orqa FPV RC combination.
The controller and receiver are paired (the receiver LED switches from red to greenish-yellow when the controller is switched on). Is there another way to verify this?
The output of running "px4-qshell ghst_rc status" on the VOXL2 is shown below. There are no UART RX bytes received, which seems to be the issue. I've checked the output of this command on working drones and they are properly receiving UART bytes. The physical connection looks fine, but I won't know until I check with a scope. Are there other diagnostic tools on the voxl that I might be able to use to help debug this?
INFO [muorb] SLPI: qshell gotten: ghst_rc status INFO [muorb] SLPI: arg0 = 'ghst_rc' INFO [muorb] SLPI: arg1 = 'status' INFO [muorb] SLPI: UART device: 7 INFO [muorb] SLPI: UART RX bytes: 0 INFO [muorb] SLPI: Telemetry disabled: Singlewire RC port INFO [muorb] SLPI: ghst_rc: cycle interval: 26442 events, 4596.45us avg, min 4520us max 5196us 49.697us rmsVersion:
system-image: 1.7.8-M0054-14.1a-perf kernel: #1 SMP PREEMPT Sat May 18 00:16:30 UTC 2024 4.19.125 hw platform: M0054 mach.var: 1.2.0 voxl-suite: 1.3.2
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login