MCP2515 CAN device on VOXL2 J10 SPI + gpio
-
I have added a MCP2515 CAN controller to the SPI bus on J10 using GPIO_46/CS1 as the interrupt gpio pin. I have added the in tree driver into the kernel. I have requested gpio 46 as the interrupt pin, but it is not taking effect. However, when it does request the gpio, you can see contention on the pin.
What do I need to do in order to configure GPIO_46 as an input gpio to use as an interrupt for this device? Below is the DT node that I am using.
+&qupv3_se14_spi {
-
status = "ok"; -
can_spi: can@0 { -
compatible = "microchip,mcp2515"; -
reg = <0>; -
interrupt-parent = <&tlmm>; -
interrupts = <46 0x8>; -
clocks = <&clk12M>; -
spi-max-frequency = <8000000>; -
};
+};
Thanks in advance!
Paul -
-
I have added a MCP2515 CAN controller to the SPI bus on J10 using GPIO_46/CS1 as the interrupt gpio pin. I have added the in tree driver into the kernel. I have requested gpio 46 as the interrupt pin, but it is not taking effect. However, when it does request the gpio, you can see contention on the pin.
What do I need to do in order to configure GPIO_46 as an input gpio to use as an interrupt for this device? Below is the DT node that I am using.
+&qupv3_se14_spi {
-
status = "ok"; -
can_spi: can@0 { -
compatible = "microchip,mcp2515"; -
reg = <0>; -
interrupt-parent = <&tlmm>; -
interrupts = <46 0x8>; -
clocks = <&clk12M>; -
spi-max-frequency = <8000000>; -
};
+};
Thanks in advance!
Paul@Paul-Handrigan , please see this post, depending on which board you have (M0054 or M0154), it may not be possible to use GPIO 46 as input :
https://forum.modalai.com/topic/4200/issue-reading-gpio-1146-pin-6-on-j10-on-voxl2
-
Reading along? Create a free ModalAI Forum account to join in.
With an account you can reply, ask your own question, get an email when a ModalAI engineer answers, and mark the reply that solved it. Your place in each thread is saved between visits.
Questions about VOXL, Flight Core, ESCs and ModalAI drones are answered here by the engineers who build them.
Register Login