ModalAI Forum

@tom
Yeah definitely not ideal, actually setting up an orange pie on linux right now to handle the flashing in the future, haha

@tom

So when I plugged it in everything lit up green and I could get into the shell. I still did the lsusb and got this back. Might have had my VM get bugged up at some point and just needed a restart to get it to work. I'll keep this post updated if I run into any more problems with the board.

@tom

Sorry should have specified, during the image reflash it will time out

Its a Voxl 2 board.

We were going through the Voxl 2 Unbricking guide and got to the step where we would reflash the image to the board. At that point it would time out.

We were running the camera calibration and it suddenly stopped communicating with the PC.

Did we overheat the unit?

We followed the steps to "unbrick" the device but it continually was timing out.

@Alex-Kushleyev Thanks for taking the time Alex this was very helpful!

@Alex-Kushleyev Thanks Alex that's much appreciated!

Hello, I'm reaching out as I've purchases a few VOXL mini ESCs and I've had 2 of the positive main power pads lift. One during soldering and the other was just bumped.

My techs are using Weller Irons and Kester 63/37 Solder, soldering around 600 degrees. As it was 2 in a row with the positive pad I wanted to reach out and see if this was too hot for the ESC.