Posts made by gus

Hi, I'm curious if you have done any temperature range tests on the Flight Core/VOXL platforms. Do you have any estimates on upper and lower ambient temperatures that should not be exceeded?

Thanks

@modaltb Great, I will check this out, thanks so much.

Hi, I would like to use more than 4 UART ports on my Flight Core. Is it possible to override the non-default (GPS1, tel1-3) ports to enable additional serial port usage? For instance, could I use port J6 as an additional TEL4 port, by adding TEL4:/dev/ttyS3 below the TEL3 line?

I am not using this port for battery messages (instead using dshot telemetry) so I could do this if the port configuration is viable, but I'm worried that making this change will screw something up on the FC, so I don't want to try it without asking here first.

Is this possible on this port or any other ports? 5 UART ports would be extremely useful to me.

Thanks,
Gus

@modaltb This is on release 1.11.1.

Alright I couldn't help myself - so it does look like Timer4 can in fact handle DShot. I replaced the second timer initialization with

initIOTimer(Timer::Timer4, DMA{DMA::Index1, DMA::Stream6, DMA::Channel2})

following the Timer4 structure listed in nuttx/src/px4/stm/stm32f7/include/px4_arch/hw_description.h

Doing that produced some interesting results. I can get DShot but it's mapped strangely, what I put on output 5 instead maps to output 7, and output 6 maps to output 5. Not sure exactly why that is, but despite that the Dshot message is certainly correct. I tested this using a test mixer where I directly mapped the throttle to a given output, and everything seemed right. Haven't tested whether telemetry works with this output mapping yet though.

Let me know if you guys investigate further.

Thanks

Hey Travis, thanks for the reply.

After further investigation I believe those bits that look inconsistent may actually be correct. It only looks like that when I enable Dshot telemetry, and of course bit 12 is the telemetry request bit. I'm not sure exactly how dshot works but I guess it makes sense that this bit isn't high on every message, since the telemetry maybe sort of 'cycles' through each output.

I am in fact able to get my dshot ESC to recognize the signal if I set the outputs to pwm, reboot, select dshot, and reboot again. I actually experienced the same thing when I was trying dshot on the Cube, so I think this aspect is fine on your end.

As far as outputs 5-8, it looks like they are on a different timer than outputs 1-4 (see boards\modalai\src\timer_config.cpp). The first 4 outputs run on Timer1 and the next 4 on Timer4, and they are initialized differently. Could your team investigate whether Timer4 is capable of Dshot? I get a little fuzzy on programming this low-level.

Cheers,
Gus

Hello,

I am trying to implement Dshot on our hexacopter, but I'm noticing 2 issues.

First, it looks like the signal has some inconsistency, as you can see in this video. This causes my Dshot ESC's signal integrity verification to fail, and as such it doesn't seem like I will be able to use Dshot with this flight controller at all as is.

Second, Dshot only appears to even attempt to run on the first 4 outputs - I'm just seeing a high signal on all other outputs.

Are there potential solutions to these issues, or are there hardware conflicts preventing Dshot from being usable for a hexacopter with this FC? We purchased this flight controller in part hoping that it would allow us to run Dshot on our hexacopter, so this issue is quite important to us.

Thank you,
Gus