ModalAI Forum

Alex,

Currently using the following Config:

M0107 -> FPC-M0036 Cable -> M0135 Upper Port -> J7 Port.

Using the same setup as in the M0107 Product Page.

Tried various setups, however, it does not see any camera connected to the VOXL2.

Firmware and settings for running MSU-0107 with the M0135 dual camera expander board. I have been trying to find a firmware and camera setup that will recognize that the camera is connected.

I see that the Starling 2 drone is utilizing a lot of micro coax cables for board and camera inter-connections. Are these special cables or are the freely available from you or a vendor? Do you have upcoming plans to use them more?

@Hector-Nevarez

system-image: 1.2.1-M0054-14.1a-perf

lsmod reports nothing:

Module Size Used by

I purchased the AWUS036ACS dongle and cant get it to work on the Voxl2. I am using a USB connection through a microhard board. When I run lsusb it sees the realtek controller however, it doesnt automatically create the wlan0 instance so I cannot connect to a wifi source. Is there something I am missing or will I have to compile a driver for the dongle before I can use it. It is one of the three that is supported on your site so I assumed connection would be relatively automatic.

Is the 5G M2 slot capable of hosting a WiFi card? Is there plans to support a particular card in the future rather than running a USB Dongle?

Thanks.