Hi everyone,

I am looking for longer 26-pin MIPI cables than the ones sold on the ModalAI website (https://www.modalai.com/collections/cables-1/products/mcbl-00084?variant=48956821602608).
Unfortunately, the replies from the contact email would only direct me to the HDZero website, where they only offer 20-pin cables there, so those won't fit.

Any chance someone could point me in the direction of where to obtain 200-250mm cables?
If necessary, I would also consider buying custom made cables, however the technical documentation link doesn't have any entries... (https://docs.modalai.com/cable-datasheets/#mcbl-00084)

Thank you already in advance for your time and support!

Edit: if you don't have longer cables, where could we buy them?

Hi @Vinny
Thank you very much for the reply and the link to the brief.
We would want to use the longer cables with a Flir Hadron. The adapter board we bought from you already came with 180mm cables, but unfortunately this is just a bit too short for our drone.
Since this is shipped with such long cables, I assume there are no issues with the bitrate/length yet at 180mm.

Do you know if this setup (Hadron with your adapter to J8) was tested in your lab with longer cables than 180mm? Any chance you could provide us longer cables at our own risk?

Hi everyone,

I am looking for longer 26-pin MIPI cables than the ones sold on the ModalAI website (https://www.modalai.com/collections/cables-1/products/mcbl-00084?variant=48956821602608).
Unfortunately, the replies from the contact email would only direct me to the HDZero website, where they only offer 20-pin cables there, so those won't fit.

Any chance someone could point me in the direction of where to obtain 200-250mm cables?
If necessary, I would also consider buying custom made cables, however the technical documentation link doesn't have any entries... (https://docs.modalai.com/cable-datasheets/#mcbl-00084)

Thank you already in advance for your time and support!

Hi everyone,

We are currently considering attaching a Flir thermal camera to my Starling 2.
I was very happy to read, that now the Boson+ is now fully supported, and the respective boards are available.

Now we are trying to assess, whether we should directly upgrade to a Hadron or "only" a Boson.
Is the Hadron supported in the same way as the Boson (since a Boson is inside the Hadron as well)?

Thank you very much for your assistance!

Just stumbled across this topic and quickly wanted to ask if it is already known when those boards will be available in the shop?
Else, would it be possible to order through email?

Thanks a lot for your feedback!