PX4 DISCONNECTED FROM UART
-
Hello, I can't connect my seeker to QGC. I have already reconfigured voxl-vision-px4 and voxl-mavlink-server to the factory setting and both of them are enabled and running.
But when I look into it by using status -l voxl-vision-px4, it says:
Jan 01 00:00:09 apq8096 voxl-vision-px4[2589]: WARNING: connected to voxl-mavlink-server but no messages from PX4
And when I check voxl-mavlink-server, it says
Jan 01 00:00:10 apq8096 voxl-mavlink-server[2710]: PX4 DISCONNECTED FROM UART
Here is my mavlink.conf on seeker
I already try my best to fix this and gets no luck...... So hope you guys can help me with it.
Sorry for interrupt your Christmas vacation.
-
Could the cabling between the VOXL and Flight Core have become disconnected? The connections should look like the image below
-
Could the cabling between the VOXL and Flight Core have become disconnected? The connections should look like the image below
@Chad-Sweet Thanks for your quick response.
I check the cable between them and it looks good to me. I also re-plugged some of them and check mavlink status, still shows disconnected.
-
Quick update, mavlink suddenly connected yesterday, but after few minutes it disconnected again. Since I didn't change any of setting, so I think it's bad contact causing the disconnection. What do you guys think of this?
-
yes, it sounds like a cable is not connected or was damaged somehow
-
S Syed Omair referenced this topic on
Reading along? Create a free ModalAI Forum account to join in.
With an account you can reply, ask your own question, get an email when a ModalAI engineer answers, and mark the reply that solved it. Your place in each thread is saved between visits.
Questions about VOXL, Flight Core, ESCs and ModalAI drones are answered here by the engineers who build them.
Register Login