Camera not recognized

TomP

Hello everyone,

We are using the Mini VOXL with the following setup:

Camera:

IMX412 Sensor COAX BD M0161
Connector:
M0155
Here are some pictures of the setup:

I need clarification about the connection. Do we need to align the number "59" written on the Mini VOXL with the connector for proper connection? Should they overlap, as shown in the image below?

Any guidance on how to connect this correctly would be greatly appreciated.

Thanks in advance!

modaltb

Hi @TomP ,

The last image you have shows correct orientation, you can find "pin1" and align to that:

For SW configuration, you want to have /usr/lib/camera/com.qti.sensormodule.imx412_fpv_0.bin for this setup off J6. Reach back out if you get stuck here.

Vinny

HI @TomP
Please remove all products off of the ESD static bags.
This bags are only used for unpowered storage/shipping when outside of a controlled ESD Work Area.
This site has a few good books you can try to pick up so your team is well prepared for ESD handling: https://www.techni-tool.com/category/Static-Protection/ESD-Training-And-Awareness-Materials