Hi,
I have just updated my VOXL 2 board from 0.9.5 to 1.0.0 - after the update voxl-camera-server no longer runs.
system-image: 1.6.2-M0054-14.1a-perf
kernel: #1 SMP PREEMPT Fri May 19 22:19:33 UTC 2023 4.19.125
hw version: M0054
voxl-suite: 1.0.0
voxl2:/$ voxl-camera-server -d 0
GPS server Connected
configuration for 1 cameras:
cam #0
name: hires
sensor type: imx214
isEnabled: 1
camId: 0
camId2: -1
fps: 30
en_preview: 0
pre_width: 640
pre_height: 480
pre_format: nv21
en_small_video: 1
small_video_width: 1024
small_video_height: 768
en_large_video: 1
large_video_width: 4096
large_video_height: 2160
en_snapshot: 1
snap_width: 4160
snap_height: 3120
ae_mode: isp
standby_enabled: 0
decimator: 1
independent_exposure:0
=================================================================
DEBUG: ------ voxl-camera-server: Starting 1 cameras
Starting Camera: hires
DEBUG: Attempting to open the hal module
DEBUG: SUCCESS: Camera module opened on attempt 0
DEBUG: ----------- Number of cameras: 0
Segmentation fault:
Fault thread: voxl-camera-ser(tid: 2315)
Fault address: 0x5664b7d6cc
Address not mapped.
Segmentation fault
Before the update I was able to stream H264 to VLC over WIFI.
I tried modifing the camera server config file to H264 instead of H265 but it has no effect.
Any assistance would be appreciated