Hi Support Team,

[This is an inquiry regarding a UVC camera.]
We are using the voxl-mini as shown below.

• hw platform: M0104
• voxl-suite: 1.4.5
• SKU: TF-M0104-6-V1-C6
• video codec(voxl-streamer): h.264
• Web camera: uvc(YUY2) format

[Inquiry]

1. We are using a web camera.
2. The Device ID changes when the camera is turned back on (see figure below).
   
   Therefore, we execute the command "systemctl restart voxl-uvc-server" every time.
3. Please tell me how to fix the Device ID.???

Thank you.
Kim.

@Moderator

Thank you for your reply.

Hi, Support team,

We're planning to connect four tracking cameras and two thermal cameras to the VOXL2.
The Flir MIPI Boson 640 is available for purchase,
but the Flir MIPI Boson 320 isn't.

Can you tell me where I can purchase the Flir MIPI Boson 320?

Thanks,

Thank you so much for your reply.
I'll test it and let you know if I have any other questions.

Regards,
Kim

@Alex-Kushleyev said in Connecting 2 Boson Cameras and 2 MIPI Cameras (4 Cameras Total):

I will follow up tomorrow with software setup details

Thank you for the prompt technical support.

Regards,
Kim

Thank you for your quick response.

We will proceed with the review using the VOXL 2 M0154.
[Questions]

1. Please tell me how to configure the SW (2 EOs, 2 Bosons, 4 cameras total).
2. Please also check if the Boson320 can be used.

Thanks

1. I want to connect 4 cameras using the VOXL2 or VOXL2-mini.

a) The camera configuration is 2 Boson cameras + 2 MIPI cameras.
Can I use 2 Boson cameras simultaneously?
b) Can I use 2 VOXL2 Mini Dual Hi-res and Boson MIPI Adapters (MCCA-M0194-2) simultaneously?

2. The Boson camera resolution is only 640x512, but I need 320x240. Is it possible to connect the 320x240 camera sold by FLIR?

Thanks,

@Jskim
Finally, I tried a test.
I tried changing the video player and the Streamer died immediately.
The conclusion is that the Streamer died even when it was in the foreground.

Thanks,

JS, Kim

@Jskim
[The phenomenon is as follows]
Video Player restart
Video works normally (about 3 minutes)
Streamer is not dead, but the video is frozen.
Looking at the top command contents, Streamer CPU usage is 2.3%.

It stops for 5 minutes and then works normally again (about 1 minute).

It stops again. (CPU usage 1.9%)
Normal operation after 5 minutes
Video freezes after 1 minute (CPU usage 2.3%)

Thanks,

JS, Kim

@Jskim
Send streamer error code

Thanks,

JS, Kim