Hi Chad,
Thanks for the directions.
I was going through the initial setup and I'm stuck at the point to connect to QGroundControl.
I'm at the same NW as the drone but when I check the status for the P4X it shows the following:
sh-4.4# systemctl status rb5-px4-start
ā rb5-px4-start.service - rb5-px4-start
Loaded: loaded (/etc/systemd/system/rb5-px4-start.service; enabled; vendor pr
**Active: inactive (dead)**
lines 1-3/3 (END)
I've tried disabling/enabling and rebooting but I still could not see the drone on the QGC app..
Wifi is now up and running:
sh-4.4# ifconfig wlan0
wlan0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 10.188.113.109 netmask 255.255.255.0 broadcast 10.188.113.255
inet6 fe80::34d3:41a2:d468:53d2 prefixlen 64 scopeid 0x20<link>
ether 00:03:7f:12:d8:ac txqueuelen 3000 (Ethernet)
RX packets 837 bytes 50588 (50.5 KB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 849 bytes 62391 (62.3 KB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
Let me know if any further configuration is necessary to have it available to connect on QGC.