Posts made by sakthi

@Vinny said in Current rating and Power sequence of VOXL-2 camera connector J6,J7,J8:

please provide us with more info and we

Hi Vinny,

Thanks for your support!

1, We need 1.2V / 1.8V/ 2.8V power domains for our sensor and ISP, In order to to turn on / off sensor and ISP properly we need a sequence, in our case 1.2V starts first and 1.8V and then 2.8V, in camera connectors J6,J7,J8 we able to find 1.2V / 1.8V/ 2.8V power domains does the power domains in connectors having any specific sequence ? and please mention the tolerance value of voltages.

2, Our camera requires around 800mA from 1.2V and 500mA from 1.8V and 2.8V would the voxl-2 able to support the requirement?

3, Regarding GPIO's we planned to boot the ISP through SPI interface but its mentioned in datasheet that SPI lines are not tested. could you please confirm on this?

Thanks,
Sakthivel

Hello there,

We are designing a custom camera for VOXl-2 carrier board for that we are in need of few information listed.
1,Maximum current source by each power domain in camera connector
2,The power sequence (Turn ON / OFF)
3,I2C / SPI / GPIO signal voltage levels

kindly provide the requested information as early as possible

Thanks,
Sakthivel