Posts made by maddyr13

@Alex-Kushleyev Great, thank you! I was able to update the drone and see the increased number of PWM outputs. However, when I flew the drone the motors got incredibly hot after a very short flight, which they had not done on previous flights prior to updating. Do you happen to know of any other changes made with this update that may have caused this?

@Alex-Kushleyev Actually, do you have the updated .deb file available that I could use?

@Alex-Kushleyev Thank you!

I am trying to attach an additional servo to my m500 flying on VOXL 2. I am using the PX4 v1.14 parameters as specified in the voxl2_io_enable_pwm.params file. When I visit the PX4 website explaining the parameters available for the drone, it is clear that there are only 4 PWM output enabling parameters defined for the VOXL 2.

I know that I will have to attach my servo to the PWM breakout board utilizing a battery eliminator circuit, so at this stage I believe validating my setup is dependent on the support being offered to the VOXL 2.

Are there any updates as to when VOXL 2 plans to support additional PWM outputs beyond the four necessary to fly the drone itself? If there are no plans to do so, I will have to roll back to VOXL 1 where I have previously tested this setup and proven it works.