voxl-calibrate-camera not working

[A Former User]

Hello,
I have custom printed checker board pattern 5x7 with each square of length 40 mm. With this checker board printed on A4 size paper I tried to kick start voxl-calibrate-camera for caliberating my stereo camera pair but this isn't working and on voxl-portal I cant see checker pattern been detected on stereo image overlay. So basically I couldn't proceed with the same.
I ran this command "voxl-calibrate-camera stereo -m -s 5x7 -l 0.04"

Please see attached image of voxl-portal which isn't able to detect pattern.

What can be the issue?

Also I tried running voxl-calibrate-camera on checkboard printed and stuck to wall and me moving camera to position board inside specified regions.

[A Former User]

Update :

I tried starting calibration with bigger checker board of size 7x9 with each square of length 0.08 as shown in the image attached but still no luck.

My VOXLCAM system image version is 3.3.0.

[A Former User]

@Chad-Sweet Any help on this issue?

[A Former User]

Hi, i think your issue is the board size, it's counting the number of inside corners not the number of squares so it should be 6x8 not 7x9