My VOXL has benn brick.

[shlee853]

Hi guys,
My VOXL has been brick.

But I don't have debug module.

Is there any method to unbrick without debug module?

especially, I have PDDL module and checked it has emergency switch to enter factory mode.

Can I recover my VOXL in emergency mode?

Thanks,

[modaltb]

Hi @shlee853 ,

Unfortunately that switch on the Microhard modem is a lower level factory emergency boot switch only. It can be used in conjunction with a factory level "QFIL" application that we can't distribute. When enabled, the device boots up into a special mode, but fastboot can't see it in this mode.

What will likely be needed is the Debug module with the "fastboot" switch.

Question: have you attempted to boot up with/without the Modem attached? Trying to eliminate possible issues.

Thanks!

[modaltb]

Also, if cameras get plugged in backwards (I've done this myself too many times....) then the VOXL might not boot up.

[shlee853]

@modaltb thanks for your reply.
I have a VOXL flight deck and I didn’t change camera installation on it.

When I stopped updating system software then my VOXL has been brick.

Ok I’ll prepare debug board to treat fast boot.

Thanks buddy